Composition
Insulin Human (rDNA) & Isophane Insulin Human 30/70 Injection 100 IU/ml: Each ml suspension contains Insulin Human (rDNA) USP 100 IU (equivalent to 3.47 mg) as 30% Soluble Insulin Human (Regular) and 70% Isophane Insulin Human.
Insulin Human (rDNA) & Isophane Insulin Human 50/50 Injection 100 IU/ml: Each ml suspension contains Insulin Human (rDNA) USP 100 IU (equivalent to 3.47 mg) as 50% Soluble Insulin Human (Regular) and 50% Isophane Insulin Human.
Indications
For the initial stabilization of diabetes in patients with diabetic ketoacidosis, hyperosmolar non-ketotic syndrome and during periods of stress such as severe infections and major surgery in diabetic patients. Treatment of gestational diabetes.
Therapeutic Class
Pharmacology
Insulin Human (rDNA) 30/70 & Insulin Human (rDNA) 50/50 start action within 30 minutes after injection, reach peak level within 2-8 hours and last about 24 hours.
Dosage
The dosage form, the dosage and the administration time of the insulin are different due to the individual differences of each patient. In addition, the dosage is also affected by food, working style and exercising intensity. Therefore, patients should use the insulin under doctor’s instruction.
Administration
Preparation before use:
- Clean your hands.
- Shake or rotate the vial gently to mix the solution uniformly and check if the insulin has the normal appearance.
- In case of using a new vial, flip off the plastic protective cap and wipe the rubber plug with an alcohol swab.
- Draw air into your syringe equal to the amount of insulin needed.
- Puncture the needle into the vial and inject the air.
- Turn the bottle and syringe upside down and withdraw correct dose of insulin into the syringe.
- Before pulling out the needle, check if there are any bubbles remain in the syringe. If so, put the syringe upright and tap the syringe to discharge the air bubbles.
Injection site:
- Choose the area where skin is less tight, such as the upper arm, thigh, buttock or abdomen.
- To avoid tissue damage, choose a site for each injection that is at least 1 cm from the previous injection site.
Injection method:
- Cleanse the skin with alcohol where the injection is to be made.
- Put the needle in such a position as to form 45° angle with the skin.
- Puncture the needle into skin and inject insulin.
- Keep the needle under the skin for at least 6 seconds to make sure the entire dose is injected.
- Pull the needle out and apply gentle pressure over the injected site for several seconds.
- Do not rub the injection site.
There are no reviews yet.